EPA
Industrial QuickBerm® 28-IQB Justrite
Art. no: 28-IQB
Please share this article with others
Copy this link. After this you can paste and share it.
Product description
Offer economical, portable spill control with quick deployment for EPA SPCC compliance
Quickly go to
Overview
Product features
- Quick and Easy Deployment – Single-piece construction enables rapid setup in minutes with no assembly required
- Space-Saving Design – Inside wall supports allow for flush placement against walls and equipment while keeping exterior areas free of trip hazards
- Durable and Weather-Resistant – Modified PVC-coated fabric resists UV exposure, extreme temperatures, and a broad range of chemicals, including oils, fuels, and acids
- Enhanced Safety Features – High-visibility yellow supports prevent interior catch hazards and keep pathways clear
- Versatile and Portable – Lightweight, collapsible design allows for easy transport and compact storage when not in use
- Easy Access – Sidewalls can be quickly lowered for effortless entry and exit from any angle
- Proudly Made in the USA – Assembled to the highest standards for top-quality performance and quick lead times
Product description
QuickBerm® secondary containment helps you comply with EPA regulations and provides dependable spill control for leak-prone containers and equipment. Sets up in mere minutes, great for efficiency and quick response under emergency spill conditions. Reinforced CriticalCorner™ design features wraparound diagonal welds for superior strength and fluid-tight reliability. Berm withstands a broad range of chemicals including petroleums and most acids, and is durable enough for extended wear. High-visibility yellow inside supports alert against potential catch hazards inside while keeping exterior free from trip hazards found in other berms with exterior support systems.
Compliances
EPA CFR 40
EPA CFR 40
264.175 Containment. (a) Container storage areas must have a containment system that is designed and operated in accordance with paragraph (b) of this section, except as otherwise provided by paragraph (c) of this section. (b) A containment system must be designed and operated as follows: (1) A base must underlie the containers which is free of cracks or gaps and is sufficiently impervious to contain leaks, spills, and accumulated precipitation until the collected material is detected and removed; (2) The base must be sloped or the containment system must be otherwise designed and operated to drain and remove liquids resulting from leaks, spills, or precipitation, unless the containers are elevated or are otherwise protected from contact with accumulated liquids; (3) The containment system must have sufficient capacity to contain 10% of the volume of containers or the volume of the largest container, whichever is greater. Containers that do not contain free liquids need not be considered in this determination; (4) Run-on into the containment system must be prevented unless the collection system has sufficient excess capacity in addition to that required in paragraph (b)(3) of this section to contain any run-on which might enter the system; and (5) Spilled or leaked waste and accumulated precipitation must be removed from the sump or collection area in as timely a manner as is necessary to prevent overflow of the collection system. (c) Storage areas that store containers holding only wastes that do not contain free liquids need not have a containment system defined by paragraph (b) of this section, except as provided by paragraph (d) of this section or provided that: (1) The storage area is sloped or is otherwise designed and operated to drain and remove liquid resulting from precipitation, or (2) The containers are elevated or are otherwise protected from contact with accumulated liquid. (d) Storage areas that store containers holding the wastes listed below that do not contain free liquids must have a containment system defined by paragraph (b) of this section: (1) FO20, FO21, FO22, FO23, FO26, and FO27. (2) [Reserved]
Technical Specifications
General specifications
| High Hazard Seismic Zone | No |
|---|---|
| Material Group | PVC |